Fujitsu SPARC T5120 Uživatelský manuál stáhnout pdf (Strana 205)

Returning the Server to Operation 179

Note – As soon as the power cords are connected, standby power is applied.

Depending on how the firmware is configured, the system might boot at this time.

Related Information

■ “Power On the Server Using the poweron Command” on page 179

■ “Power On the Server Using the Front Panel Power Button” on page 180

▼ Power On the Server Using the

poweron Command

Note – If you are powering on the server following an emergency shutdown that

was triggered by the top cover interlock switch, you must use the poweron

command.

● Type poweron at the service processor prompt.

You will see an -> Alert message on the system console. This message indicates

that the system is reset. You will also see a message indicating that the VCORE has

been margined up to the value specified in the default .scr file that was

previously configured. For example:

Related Information

■ “Power On the Server Using the Front Panel Power Button” on page 180

-> poweron

-> start /SYS

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 239 240

Žádné komentáře

Fujitsu SPARC T5120 Uživatelský manuál Strana 205