Fujitsu M3000 Uživatelský manuál stáhnout pdf (Strana 319)

100

101

setssh(8)

System Administration 295

■ The setssh(8) command can register one user public key at a time.

■ In time of setssh(8) command execution, finish the input of user public key by

pressing Enter and then pressing "Ctrl" and "D" (EOF).

■ In case the XSCF unit is duplicated configuration, the setting automatically

reflected to the standby XSCF. When there is a defect on the standby XSCF, it

leads to an error and the setting will be reflected to the active XSCF only.

■ When you use the setssh(8) command to disable the SSH service (setssh -c

disable), the SSH service is disabled immediately. At this time any open SSH

sessions are terminated.

For all other settings using the setssh(8) command, you must reboot the XSCF

using rebootxscf(8) command for the changes to take effect.

■ Using the showssh(8) command, you can check the current settings of the SSH

service.

EXAMPLES

EXAMPLE 1 Starts the SSH service.

EXAMPLE 2 Starts the SSH service. Automatically replies with "y" to the prompt.

EXAMPLE 3 Starts the SSH service. Automatically replies with "y" without displaying the

prompt.

EXAMPLE 4 Stops the SSH service.

EXAMPLE 5 Generates a host public key for SSH2.

XSCF> setssh -c enable

Continue? [y|n] :y

Please reset the XSCF by rebootxscf to apply the ssh settings.

XSCF>

setssh -y -c enable

Continue? [y|n] :y

Please reset the XSCF by rebootxscf to apply the ssh settings.

XSCF>

setssh -q -y -c enable

XSCF> setssh -c disable

XSCF> setssh -c genhostkey

Host key create. Continue? [y|n] :y

Please reset the XSCF by rebootxscf to apply the ssh settings.

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 559 560

Komentáře k této Příručce

Žádné komentáře

Fujitsu M3000 Uživatelský manuál Strana 319

Komentáře k této Příručce

Související produkty a manuály pro Software Fujitsu M3000