Fujitsu F2 Uživatelský manuál stáhnout pdf (Strana 122)

108

CHAPTER 2 DEPENDENCE FUNCTIONS

2.2.8.2 Setting Single Trace

The following settings (1) to (4) are required before executing single trace. Once these

settings have been made, trace data is sampled when a program is executed.

(1) Set event mode to normal mode.

(2) Enable trace function.

(3) Set events, sequencer, and delay count.

(4) Set trace-buffer-full break.

■ Setting Single Trace

The following settings are required before executing single trace. Once these settings have been made, trace

data is sampled when a program is executed.

(1) Set event mode to normal mode.

Use SET MODE command to make this setting.

(2) Enable trace function.

Use the ENABLE TRACE command. To disable the function, use the DISABLE TRACE command. The

default is Enable.

(3) Set events, sequencer, and delay count.

Trace sampling can be controlled by setting the sequencer for events. If this function is not needed, there

is no need of this setting.

To set events, use the SET EVENT command. To set the sequencer, use the SET SEQUENCE command.

Furthermore, set the delay count between sequencer termination and trace ending, and the break operation

(Break or Not Break) when the delay count ends. If the data after event occurrence is not required, there is

no need of this setting.

If Not Break is set, the trace terminates but no break occurs. To check trace data on-the-fly, use this setup

by executing the SET DELAY command.

Note:

When the sequencer termination causes a break (sequential break), the last executed machine cycle

is not sampled.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 353 354

Žádné komentáře

Fujitsu F2 Uživatelský manuál Strana 122