Fujitsu PCI Gigabit Ethernet 4.1 Update 2/ 5.0 for Oracle Uživatelský manuál stáhnout pdf (Strana 43)

- How to Return to Default FCode Settings (Auto-Negotiation Mode):

- To return to default FCode settings, execute the following command from the ok prompt, or power cycle the system.

ok reset-all

3.6 Network Installation

See the document "

Install Server Build Guide I/O Device Driver (SPARC Enterprise)

" for the installation procedure.

3.7 VLAN Interface Setup

This section provides information about the VLAN interface and setting up the VLAN interface.

- 3.7.1 IEEE 802.1Q TagVLAN

- 3.7.2 Setting Up the VLAN Interface

3.7.1 IEEE 802.1Q TagVLAN

The IEEE 802.1Q TagVLAN function is described in the following.

- IEEE 802.1Q TagVLAN

- The TagVLAN function provides the ability to create two or more separate networks that share a single physical interface. Virtual

interfaces are created by assigning VLAN IDs (VIDs) to a physical interface. Communication between different VID interfaces on

the same host is not allowed. The following example shows a comparison of the networks created without and with the TagVLAN

feature.

Figure 3.1 Example of using VLAN

By using a VLAN, traffic management of two or more networks on a single physical interface can be done.

In order to create a VLAN environment, a switch capable of supporting a VLAN setup (VID and Tagged/Untagged setting) is required.

- 37 -

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 92 93

Žádné komentáře

Fujitsu PCI Gigabit Ethernet 4.1 Update 2/ 5.0 for Oracle Uživatelský manuál Strana 43