Fujitsu SPARC M4000/M5000 Uživatelský manuál stáhnout pdf (Strana 15)

2-1

CHAPTER

Preparing to Install the Server

This chapter describes the items you are required to check, the environmental

requirements for installation, installation areas, and other related matters. It contains

the following sections:

■ Section 2.1, “Safety Precautions” on page 2-1

■ Section 2.2, “Before Installing the Server” on page 2-2

■ Section 2.3, “Tools and Equipment” on page 2-9

2.1 Safety Precautions

To protect both yourself and the equipment, observe the following precautions when

possible:

■ Observe the precautions, warnings, and notes on handling shown on the server.

■ Use an electrostatic discharge (ESD) jack or wrist or foot strap when possible.

■ Do not block any ventilation holes.

■ Do not install the server at a location exposed to direct sunlight or near a device

that may become hot.

■ Do not install the server at a location that has a lot of dust or that is exposed to

corrosive gases or air with a high salt concentration.

■ Do not install the server at a location exposed to frequent vibrations. Install the

system on a flat and level surface.

■ Use grounding wires of class 3 or higher. Sharing any grounding wire will lead to

a malfunction.

■ Do not place cables under the equipment or have cables stretched tight. Do not

disconnect a power cord to the server while its power is on.

■ Do not place anything on the server or perform any work directly above it.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 75 76

Žádné komentáře

Fujitsu SPARC M4000/M5000 Uživatelský manuál Strana 15